Dishwasher Hookup Instructions

The fundamental methods are the same whether you’re installing a new washer or just replacing an existing one. A water supply, a drain column, and an electrical encounter are requirements for all dishwashers. Fortunately, if you follow the manufacturer’s directions, all of these contacts are fairly straightforward to render.

Shut the water gate under the drop and switch off the dishwasher’s control loop, which is typically a dedicated switch, before starting any work. To prevent water and steam harm to your benchtops, you might also want to drop down some fabric or plywood.

Remove the top exposure board from the foundation of your old dishwasher after turning off the power and water to access the connections for the water, electricity, and dump lines. A handle on the panels will probably need to be taken off, and a wire connecting the earth wire—which should be copper or green—must be removed. A 90-degree hip can be installed to stop column kinks, or the water supply inlet may include female threads for connecting a common accommodating water line.

Replace the cover, discharge the line from the package, and turn off the electricity. Thread the finish of the plug-in wire into the opening if you’re using one that will be connected to an electrical outlet. The circuits should be joined together in the same color, capped with cable nuts, and electric taped. Finally, tighten the electric box’s green lock by placing the brass ground wire underneath it.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top